Page 334 - IJB-10-3
P. 334
International Journal of Bioprinting Acoustic analysis of 3D-printed ossicles
Figure 2. Verification of umbilicus displacement of tympanic membrane.
Figure 3. Verification of stapes floor displacement.
on the Vickers hardness test. The unit of the Vickers molded parts were measured with an electronic universal
hardness test is HV. The unit of friction and wear test is the testing machine. The tensile test can determine the
wear volume in mm . The unit of density test is g/cm . The elongation, elastic modulus, yield strength, proportional
3
3
tensile test of titanium alloy was TC4 prepared via SLM, limit, area reduction, and other performance indicators
and stainless steel 316L and FDM-prepared HA/PCL of the material. The unit of the tensile test is MPa.
Volume 10 Issue 3 (2024) 326 doi: 10.36922/ijb.2040
