Page 45 - MSAM-2-4

Materials Science in Additive Manufacturing MAM for orthopedic bone plates: An overview

under four-point bending load utilizing machine learning https://doi.org/10.3390/inventions8020052
techniques. J Mech Behav Biomed Mater, 143: 105885.
110. Bassis M, Ron T, Leon A, et al., 2022, The influence of
https://doi.org/10.1016/j.jmbbm.2023.105885 intralayer porosity and phase transition on corrosion fatigue
of additively manufactured 316L stainless steel obtained by
105. Wang C, Tan XP, Tor SB, et al., 2020, Machine learning in direct energy deposition process. Materials, 15: 5481.
additive manufacturing: State-of-the-art and perspectives.
Addit Manuf, 36: 101538. https://doi.org/10.3390/ma15165481
https://doi.org/10.1016/j.addma.2020.101538 111. Bambach M, Sizova I, Kies F, et al., 2021, Directed energy
deposition of Inconel 718 powder, cold and hot wire using a
106. Einhorn TA, Gerstenfeld LC, 2015, Fracture healing: six-beam direct diode laser set-up. Addit Manuf, 47: 102269.
Mechanisms and interventions. Nat Rev Rheumatol,
11: 45–54. https://doi.org/10.1016/j.addma.2021.102269
https://doi.org/10.1038/nrrheum.2014.164 112. Negi S, Nambolan AA, Kapil S, et al., 2020, Review on
electron beam based additive manufacturing. Rapid Prototyp
107. Ahn DG, 2021, Directed energy deposition (DED) process: J, 26: 485–498.
State of the art. Int J Precis Eng Manuf Green Tech, 8: 703–742.
113. Tilton M, Lewis GS, Bok Wee H, et al., 2020, Additive
https://doi.org/10.1007/s40684-020-00302-7 manufacturing of fracture fixation implants: Design,
108. Singh A, Kapil S, Das M, 2020, A comprehensive review of material characterization, biomechanical modeling and
the methods and mechanisms for powder feedstock handling experimentation. Addit Manuf, 33: 101137.
in directed energy deposition. Addit Manuf, 35: 101388. https://doi.org/10.1016/j.addma.2020.101137
https://doi.org/10.1016/j.addma.2020.101388 114. Schappo H, Giry K, Salmoria G, et al., 2023, Polymer/
calcium phosphate biocomposites manufactured by selective
109. Casalino G, Karamimoghadam M, Contuzzi N, 2023, Metal
wire additive manufacturing: A comparison between arc laser sintering: An overview. Prog Addit Manuf, 8: 285–301.
laser and laser/arc heat sources. Inventions, 8: 52. https://doi.org/10.1007/s40964-022-00332-4

Volume 2 Issue 4 (2023) 17 https://doi.org/10.36922/msam.2113