Page 618 - IJB-10-3

International Journal of Bioprinting Wireless module system applied on 3D-printed implant

Figure 4. (a) Strain gauge glued to the inner right buccal wall of the reconstructed implant halfway up its height. The back cover was secured in place with
screws. The reconstructed implant was fixed onto the remaining mandibular ABS bone model with bone screws as the test sample. (b) The samples were
clamped upside down onto a test machine, the condyle head was fixed in an embedded resin block, and the testing sample received cyclic loads to the right
mandibular molar/premolar area of the mandibular bone model.

Volume 10 Issue 3 (2024) 610 doi: 10.36922/ijb.2553